Plumbing & HVAC Services Edgerton OH

Customer is having a hard time getting hot water to the upstairs radiator. I recommended that he should get a circulation pump for the upstairs. Customer says he will do it on his own.

The customer reported their heating system was not emitting warm air and was making unusual sounds. Upon inspection, I identified a faulty ignitor (model IG1121) and a worn blower motor (model BM2123) as the culprits. I replaced the ignitor and blower motor, then recalibrated the system for optimal performance. Post-repair, the heater resumed producing warm air quietly and efficiently.

For this job, the customer was having problems with no hot water. So I diagnosed the electric water heater to find, the heating element was bad. So I talked to the customer what I found, and I recommend replacing the heating element and the thermostat. With the customer’s permission, I created an estimate for both parts, and she gave the OK to have them replace After removing the bad parts, and installing the new ones, I checked the operation of the water heater and found it Working properly. I did not find any other issues with this system The water heater is working in normal operation

For this job, the system would light the burners, and would stay running for a couple seconds, then shut off. Checking the plane sensor, I found it pretty dirty, and the readings were low. After cleaning the flame sensor, I proceeded to check the furnace and found the operation working in normal condition. The furnace lit up and stayed running. I could not find any other issues with the system. The furnace is working in normal operation

Repaired ductwork and flex lines. (Water damages) After repairing the water damages in the system, I did not find any other issues with the system. The supply and return got proper airflow

For this job, I performed maintenance on the furnace. After checking everything, I found that the burners are rusted and showing flakes on the outside and inside of the burners. I also had to adjust the gas pressure as well, because it hasn’t been service since two years ago. I did recommend to the customer replacing the burners, and he gave the OK to have that replace. Part and labor is under warranty The humidifier pad has been replaced The filter has been changed Filter size is 16 x 25 x 5 AirBear The furnace is working in normal operation.

For this job, I replaced the relief valve on the water heater. After I install the park, I noticed there was a shut off valve leaking above the water heater. After talking to the customer about replacing that valve, he gave me the OK to have that done. After replacing the shut off valve for the upstairs, turning the water back on, I checked for leaks, and found none. After bleeding the waterlines to the kitchen and bathrooms sink, I did not find any other issues with this system. I did notice there was two other valves had corrosion and I talked to the customer about replacing those valves when they start leaking. He said, when the wood burner goes out, He would like for us to do a couple things on the waterline. As of right now, he does not want those valves replace.

Just finished fixing an HVAC system for a client in Edgerton, OH. Repaired a faulty capacitor in the Carrier Infinity 96 gas furnace. Restored efficient heating and ensured comfort for the client. Timely repair prevents discomfort and ensures reliable performance during cold weather.

Just completed repairs on air ducts in an Edgerton, OH home. Sealed leaks and reinforced connections on the flexible ductwork. Improved airflow efficiency and reduced energy waste. Enhanced indoor air quality and comfort for the homeowner while lowering utility costs. Efficient repairs ensure optimal HVAC system performance and longevity.

Changed out Lav faucet downstairs

Checked furnace as it was Not keeping a flame. Cleaned flame sensor, that fixed the issue and the furnace runs fine. Customer does not want gold plan

Installing a new kitchen sink and adding shut off. Rebuilding guts in upstairs stool and capping drain and water lines on lav in same bathroom. capping upstairs lav is included in the toilet rebuild.

Kitchen sink faucet install

Found glass fuse in bottom of water heater to be blown. Also found chimney had no chimney liner. Told customer they would need a chimney liner and new glass fuse. Customer refused chimney liner and we will not repair glass fuse until chimney liner is installed.

Replaced water line in crawlspace and up to sink. Need to return to replace a small section of 1/4 line under sink to improve water flow from the faucet.

Tried to make repair to water line. Waterline is very old and will not cooperate. Need to return with 3/4 pex and a small bit of 1/2 to redo water line from water heater. Capped waterline for a temporary repair.

Performed tune up on furnace. Found customer needs a new thermostat. Customer will supply and install their own.

Installed customer supplied water softener and verified proper operation.

For this job the furnace would try to light, but the gas valve would not come on. so blowing in to the pressure switch, I turned the system back on, and the furnace lit up and stayed running I recommend to the customer having their annual tuneup done, because that could’ve been prevented if they had their tuneup done. I did not find any other issues with the system

Drainage system cleaning for a residential customer. Upon my arrival to the home, I performed a thorough cleaning of the drains. The cleaning ensures that the systems are free of obstructions and functioning well to remove water from the home. The customer was pleased with the service.

Went out to a customer's home to repair their water heater. After inspected the system, I determined that a bad gasket was the root of the system's problem. I was able to replace the gasket on the water heater to bring it back to working order. The water heater is providing reliable hot water again for the home.

For this job, I took the drain pan off and reseal it with high sealant. After reinstalling the drain pan, I checked the operation of the furnace, and I found everything working great. I did not find any other issue with this system

Performed precision tune up on the heat system and verified everything was working properly. Found signs of roof jack to be failing. Furnace is ready for replacement, but customer stated they are going to try to get through the winter with it.

Went out to repair a customer's water heater that was leaking. I inspected the water heater and found that the drain valve was leaking, which was causing the water heater to lose pressure. I replaced the drain valve and then checked the water heater's temperature and pressure relief valve. The valve is no longer leaking and the water heater is working properly again.

Went out to a residential home to clean their drainage systems. Upon arrival, a thorough cleaning was performed. The systems are now free of obstructions and functioning well to remove water from the home. The customer was pleased with the performance.